Wooden gates and timber garage doors handcrafted to your own sizes!

Wooden driveway gates Gate-Expectations Wooden gates manufactured to your own sizes
Tel - 01745 362444
drivewaygates@woodworkersuk.co.uk
Fax - 01745 531001
Home | Wooden gates | Wooden pedestrian gates | Wooden estate gates | Wooden garage doors
Fence panels | Bespoke wooden gates | How to measure | FAQ | Contact us | Ordering |Feedback | Sitemap

Wooden driveway gates

You are here - Page 1 (of 4) Derwent & Thirlmere driveway gates

Wooden driveway gates - Page 2 Keswick & Caldbeck driveway gates
Wooden driveway gates - Page 3 Coniston & Grasmere driveway gates
Wooden driveway gates - Page 4 Curved headed & Kendal driveway gates
All our hardwood driveway gates (Meranti & Idigbo) and softwood driveway gates (Scandinavian Redwood) are made to measure in both height and widths.

Derwent driveway gates

Shown right is the fully boarded Derwent wooden gate in Meranti.
Also available in Idigbo and Softwood.

Curve rises by 6'' (150mm) from the lowest point.

Alternatively, if you prefer the curve can slope down from the stiles to the centre.

Below is the rear view of the Derwent.

The Derwent is also available as open boarded wooden gate.

 Wooden gates - The Derwent by Gate Expectations
Handcrafted wooden driveway gates

Specifications

Stiles, head,  Ex 3'' x 3'' (75mm x 75mm)

Rails, braces,  Ex 3'' x 2 1/2'' (75mm x 63mm)

Infill T+G boarding EX 4'' x 3/4''  (100mm x 19mm)
The specification for the Derwent open boarded gate is the same except for the infill T+G boards, which are replaced with - infill boarding Ex 3'' x 3/4 " (75mm x 19mm)  spaced at gaps no greater than 2'' (50mm).

Need ironmongery? We have a full range of ironmongery for our wooden gates in packs and available individually, see our gate ironmongery page for more information.

Measuring up for your gates? See our measuring up for wooden gates page!

Thirlmere driveway gates

Wooden gates ~ The Thirlmere by Gate Expectations

Shown left is a close boarded pair of Thirlmere wooden gates in softwood. Curve rises by 6'' (150mm) from lowest point.

Specifications

Stiles, head, Ex 3'' x 3'' (75mm x 75mm)

Rails, braces, Ex 3'' x 2 1/2'' (75mm x 63mm)

T+G infill board (close boarded gate only) Ex 4" x 3/4 " (100mm x 19mm)

Pictured right is the rear view of the Thirlmere.

Again, if you prefer the curve can slope down from the stiles to the centre.

The Thirlmere is also available as open boarded gate.

The specification for the Thirlmere open boarded gate is the same except for the T+G infill boards which are replaced with - infill boarding Ex 3'' x 3/4'' (75mm x 19mm) at gaps no greater than 2'' (50mm)

 Wooden driveway gates manufactured to your own sizes

If you like either of these gates then please contact us with the sizes you require.

Need hinges and latches for your wooden gates? Then please see our wooden gate ironmongery section.
Back to Wooden gates Forward to Wooden driveway gates page 2
All content © copyright 1997-2010. All rights reserved.